Virtual audio cable 4.093/9/2023 ![]() ![]() The easiest way to make use of this, is to just set the broadcast audio device as your default: That's it! Now, any audio that is played to the device you've set up for loopback will get broadcast via snapserver. Or starting it via command line (use this for troubleshooting if something doesn't work): ![]() Virtual Audio Cable works well for this:įinally, it's just a matter of configuring the Broadcast tool within Snap.Net: Or you can install a virtual audio device and just use that. There are 2 ways to work around this: either use an audio device which is not connected to any speakers (in my case I have a Digital Audio interface on my motherboard which isn't hooked up): Volume and mute of your audio device is also applied to loopback, so you can't mute one without also muting the other. audio being captured from your main speakers would just echo back ~1000ms after being broadcast. In most cases you won't want to use your main output device, because you can't use it for loopback and playback at the same time. Next, you need to choose an audio device from your PC to use for capturing loopback from. ![]() Note: If is unable to connect to your server even though the above config is added correctly, try using "0.0.0.0" as ip instead (see #29 ) Stream = tcp://?port=4953&name=snapbroadcast To make this work, you first need to set up a stream on snapserver which listens for incoming audio data over TCP. host -port 4953 -type -soundcard x (where x is the number of the soundcard identified via -list) Setup I can't think of many practical applications for broadcasting your own voice around the house, other than pranking the wife and kids in a thousand different ways. It's also possible to capture the audio from any input device (eg. This also works really well with meta streams, as we only send audio to the server when something is actually played (silence is not sent). The delay between the audio being captured on your PC will more or less equal the buffer setting in snapserver which defaults to 1000ms (plus the network latency between your PC and snapserver, which should be negligible in most cases). It uses Wasapi loopback to capture the audio coming through your audio device, and sends it to snapserver for syncronized playback. The purpose of this tool is to make it possible to stream audio from your Windows PC to snapserver. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |